Braided fuel hose

[Jamieg285]

I now have all the fittings I need to properly plumb the carb in  (from the existing pump)

I tried to put the ends on the fuel hose, but it didn't seem to fit - the braid is stopping the end going on.

I was going to just trim the braid back, but thought it might be a good idea to see if there is a 'proper' way to do them.

Anyone know?

[55starchief]

Quoting: Jamieg285

Anyone know?

do these fittings have a gromet and the pipe an inner liner?

[Jamieg285]

Quoting: 55starchief

do these fittings have a gromet and the pipe an inner liner?

Ooo look, a squirell.

[55starchief]

Quoting: Jamieg285

Ooo look, a squirell.

bring the pipe and fitting with you tomorrow and i will show you

[Jamieg285]

Quoting: 55starchief

bring the pipe and fitting with you tomorrow and i will show you

I can't make it


The fitting is 2 piece - red bit and blue bit. Red bit unscrews from blue bit, clamping hose.
Hose is 2 piece - rubber with steel braid.

I can't slide the red bit through the red bit, to place over the 'barb' on the blue bit.

[55starchief]

What hose and ends as there is technical information on ther holley website of how to terminate the hose

[Jamieg285]

It Jegs brand hose and ends.

[Incursus]

Quoting: Jamieg285

Quoting: 55starchief
do these fittings have a gromet and the pipe an inner liner?

Ooo look, a squirell.

PMSL